Texas House of Representatives · 89th Legislature, Regular Session
Members who authored, joint-authored, or co-sponsored this bill.
SourceLegiScan (CC BY 4.0)89R
AI summary unavailable. We’re still building out our data, so newer and more active legislation has better coverage.
Each version links to the authoritative document on capitol.texas.gov.
89R958 MP-D By: Harris H.B. No. 3314 A BILL TO BE ENTITLED AN ACT relating to certain energy efficiency performance standards for residential construction. BE IT ENACTED BY THE LEGISLATURE OF THE STATE OF TEXAS: SECTION 1. Chapter 388, Health and Safety Code, is amended by adding Section 388.0045 to read as follows: Sec. 388.0045. RESIDENTIAL BUILDING ENERGY EFFICIENCY
PERFORMANCE STANDARDS FOR ATTIC AND RAFTER ASSEMBLIES. (a) This section applies only to residential construction. (b) Notwithstanding any requirement contained in an energy code adopted under Section 388.003(a) or (b), or a local amendment adopted under Section 388.003(d), pertaining to the insulation of unvented attic or unvented enclosed rafter assemblies, a local jurisdiction shall consider an unvented attic or unvented enclosed rafter assembly to be in compliance with the requirements of the portion of the energy code administered and enforced by that local jurisdiction pertaining to the insulation of unvented attic or unvented enclosed rafter assemblies if: (1) the attic or rafter assembly is insulated and air sealed with air impermeable insulation to an R-value of at least: (A) 20 if the attic or rafter assembly is located in climate zone 2 or 3; or (B) 26 if the attic or rafter assembly is located in climate zone 4; and (2) the building in which the attic or rafter assembly is located: (A) attains a blower door test result of less than 3.0 ACH50; (B) has a mechanical ventilation system that does not rely solely on a negative pressure strategy; (C) if insulation is installed below the roof deck and the exposed portion of the roof rafters is not already covered by air impermeable insulation to an R-value of at least 20 or 26, as applicable, has the exposed portion of the roof rafters wrapped in insulation to an R-value of at least 3, except that the rafters are not required to be covered by insulation if: (i) the rafters are directly covered by drywall or finished ceiling; or (ii) continuous insulation is installed above the roof deck; and (D) contains inside the building's thermal envelope the building's indoor heating, cooling, and ventilation equipment, including ductwork. SECTION 2. This Act takes effect September 1, 2025.
Statewide figures for the subjects tagged on this bill, to explore on the Data map. They describe Texas — not this bill or its effects.
SourceU.S. Census Bureau (ACS) & CDC PLACESstatewide Data layer
Each subject links to other 89R bills tagged the same way.
SourceLegiScan (CC BY 4.0)subject tags
SourceTexas Legislative Council (capitol.texas.gov)89R
No recorded roll-call votes on this bill.
SourceLegiScan (CC BY 4.0)89R
SourceTexas Legislative Council (capitol.texas.gov)official bill text (capitol.texas.gov)
SourceLegiScan (CC BY 4.0)official fiscal notes & analyses (TLC)
Perch never collects comments itself — it points you to the Legislature's own hearing schedule and official public-comment channels (ADR-0007).
Official hearings & comment (capitol.texas.gov) →SourceLegiScan (CC BY 4.0)hearing schedule